Browse Categories
Search
Adhesive Masks
AM
Reproduces pull area of 1/2" Pull-Stub
Your Price: $50.00

Quantity Discounts - Order a quantity in the range below to receive the discount

QuantityAmount
3 to 20$45.00

Detailed Description



Tired of struggling to remove the cut-off rings before performing your PATTI Pull Test?

Annoyed by the care needed to place a cut-off ring over the pull-stub without disturbing your uncured epoxy?

The solution is here and we call them SEMicro Adhesive Masks.


If you are familiar with adhesion testing, you know how important it is to reproduce the area that is pulled. If a technician performed a pull-test without properly defining the area, then the epoxy would seep out from under the pull-stub and would cure to the sample prior to testing. This would result in an effective pull that is larger than 1/2", and the corresponding tensile strength would appear to be higher than it actually is!

At the request of some of our customers we have developed an alternative: the Adhesive Mask. This low tack, donut shaped piece of plastic has a 1" O.D. and a 1/2" I.D and is perfect for adhesion testing. Before testing, place an Adhesive Mask on the sample at the site to be tested. Apply your epoxy to the face of a pull-stub and to the center of the Adhesive Mask. The Masks are thick enough that once the pull-stub is applied to the test site at the center of the Mask, it can be slid around until it "locks" into place. Once the epoxy has cured, perform your test as usual. Note that these Masks do not need to be removed like the cut-off rings! This is because the low-tack adhesive of the Adhesive Mask has such a low tensile strength that it does not make a measurable difference in a pull test. The larger outer diameter prevents the epoxy from contacting the sample at any location other than the 1/2" where the pull-stub rests.

Note: Quantities in multiples of 3 will shipped as a roll of 300 masks.
Smaller quantities or partial rolls will shipped as bags of 100 masks unless otherwise requested.

Despite the fact that these Adhesive Masks are so much easier to use than our previous cut-off rings,
they cost less!

Try them today!

It appears you don't have a PDF plugin for this browser. No biggie... you can click here to download the PDF file.

Related Products

3M #1838 Epoxy Kit, 3.6 ounces
Your Price: $99.00
3M #1838 Epoxy Kit, 3.6 ounces
Good General Purpose Epoxy Adhesive
PIPS Pull-stubs, 1/2" diameter, Pkg of 100
Your Price: $159.00
PIPS Pull-stubs, 1/2" diameter, Pkg of 100
unavailable
Adhesive for PIPS - Light Cured
Your Price: $75.00
Adhesive for PIPS - Light Cured
3M DP460 Epoxy Refill - 1.25 oz
Your Price: $34.00
3M DP460 Epoxy Refill - 1.25 oz
The strongest adhesive we stock!
3M DP460 Epoxy Kit
Your Price: $149.00
3M DP460 Epoxy Kit
Complete 3M DP460 Epoxy Kit with EPX Plus II Applicator and Mixing Nozzles
Aluminum Pull-Stubs, 1/2" in diameter, Pkg of 100
Your Price: $159.00
Aluminum Pull-Stubs, 1/2" in diameter, Pkg of 100
Our inexpensive, Standard Replacement Pull-Stubs

Product Reviews

(0 Ratings, 0 Reviews)
Shopping Cart
Your cart is empty.
Mailing Lists