Browse Categories
Search
ReliaPull® Adhesion Tester (Tape Test Method)
ReliaPull®
Tape test results you can rely on pull after pull. Free Shipping!
Your Price: $2,999.00

Detailed Description

About the ReliaPull®:

The ReliaPull® Adhesion Test Equipment was built to help reduce the human variation imposed on the results of Tape Tests performed manually. This equipment mechanizes the test. Tape tests are performed in many industries requiring a quick check on the adhesion of inks, paints or coatings to a surface.

There are multiple standards written to describe consistent ways to perform the tape test, however, experience has proven it is very difficult for one operator to perform the test the same way each time, much less for multiple operators to duplicate the method.

By using the ReliaPull® Adhesion Test Equipment to perform your tape tests, it doesn’t matter who pulls the lever; the method is repeated exactly the same way each time.

ReliaPull® gives you results you can rely on.

Coming Soon: Watch our website for our direct replacement for Permacel P99 Tape Test Tape commonly used for ASTM D3359 (P99 no longer manufactured)!
It can be used to compare results previously obtained with the Permacel P99. It works great with the ReliaPull® for testing coatings!

ReliaPull® adhesion test equipment Demonstration Video

How ReliaPull® Works:

Step 1: Wind any tape you would normally use to conduct a tape test, for example 600, 610, 810…, through the equipment as shown. Any tape on a 3” core that is between 1/4” and 1” wide will work.

Step 2: To begin a test, tip the equipment up-right, grab the handle attached to the application brush and pull up to dispense a length of fresh tape for each test. Typical standards suggest approximately 3”, however, we’ve found it beneficial to use 7" or more to see patterns of adhesion.

Problems with Current Methods: Tape on typical dispensers has area that is exposed to drying or debris. When done by hand, oils from fingers or other debris can get on the adhesive. Tape easily tangles.

Step 3: Place the equipment on the area of the substrate to be tested. Return the brush to its home position. Note, the brush counter-rotates across the tape with consistent pressure and application motion, therefore this operation can be repeated by any operator.

Problems with Current Methods: Bubbles or missed areas occur. Different application pressures, methods or patterns cause different bonds between the tape and the stubstrate. This is very difficult to repeat by hand or from one operator to another.

Step 4: Activate removal. When the tape removal is activated a roller is lowered to ensure the tape is removed at 180 degrees from the angle of application. Again, a repeatable action.

Problems with Current Methods: It is nearly impossible for tape to be pulled at the same angle and rate by each operator, each time, by hand. Final results depend on how the operator performs each test.

Step 5: Review results. A viewing area is provided in the front of the equipment. Use the same criteria you normally use or reference the appropriate standard. You have the option of removing the section of tape just used for testing to keep with your records/retains. Alternatively, you may record the date/job number on the tape and store on the spool as a record of performing the tests. You may also dispose of the tape neatly as the spool becomes full.

Problems with Current Methods: Tape curls, tangles and sticks to fingers. Wads of tape end up strewn across work area. Tape must then be attached to the sample or another record.

ReliaPull® adhesion test equipment Demonstration Video

Related Products

Cross-Hatch Test Tape Suitable for ASTM D3359 Adhesion Testing, 60 Yd roll
Your Price: $34.95
Cross-Hatch Test Tape Suitable for ASTM D3359 Adhesion Testing, 60 Yd roll
Manufactured specifically as a replacement for the now Discontinued Permacel P-99!

Product Reviews

(0 Ratings, 0 Reviews)
Shopping Cart
Your cart is empty.
Mailing Lists